Model netgear_r6220
Flash layout
| Region | Label |
|---|---|
0x100000-0x100000 |
SC PID |
0x2e00000-0x100000 |
factory |
0x200000-0x400000 |
kernel |
0x4200000-0x3c00000 |
reserved |
0x0-0x100000 |
u-boot |
0x600000-0x1c00000 |
ubi |
Comments
General
The port mapping on this device is backwards relative to the printed numbers 1-4 on the device. This can be important when configuring LEDE’s switch features since Physical 1 –> LAN4, Physical 2 –> LAN3, Physical 3 –> LAN2, and Physical 4 –> LAN1.
WLAN
MIMO 2x2
Installation
LuCI Web Interface/uhttpd (also ssh) may NOT be enabled across power cycling after installation, or hard reset. If not - can test by power cycling first, a hard reset brings it back - then ssh, enter ‘/etc/init.d/uhttpd enable’ on the command line, then ‘reboot’ or ‘/etc/init.d/uhttpd start’ before power cycling or backing up a configuration. Restoring a configuration from after this had been applied also solves the problem.
| Netgear R6220 | |
|---|---|
|
|
| Latest release | 18.06.2 |
| Device Type | WiFi Router |
| Vendor | Netgear |
| Model | R6220 |
| Flash | 128 MB |
| RAM | 128 MB |
| CPU | MediaTek MT7621ST (ramips) 1 x 880MHz |
| Ethernet ports | 5 x GBit — 0 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n 5Ghz: a/n/ac |
| USB | 1x 2.0 |
| Switch | MediaTek MT7621ST |
| Bootloader | U-Boot |
| Power Supply | 12 VDC, 1.5 A |
| Serial | check_circle |
| Additional resources | |