Model tp-link_tl-wr710n_v2-0

Installation

Flashing via webinterface

  • Download the factory firmware image offered above to your Computer.
  • Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded lede-17.01.5-ar71xx-generic-tl-wr710n-v2-squashfs-factory.bin file. Click Upgrade.
  • If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
  • Connect to 192.168.1.1 with your web browser
  • Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!

Comments

General

wallwart size; built in AC PSU

TP-Link TL-WR710N v2.0 (EU)
Latest release 17.01.5 Discontinued
Device Type WiFi Router
Vendor TP-Link
Model TL-WR710N
Flash 4 MB warning
RAM 32 MB
CPU Atheros AR9331 (ar71xx)
1 x 400MHz
Ethernet ports 0 x GBit — 2 x 100Mbit
WiFi

2.4Ghz: b/g/n

USB 1x 2.0
Switch Yes, serving LAN port only (eth1)
Bootloader U-Boot
Power Supply 100-240 VAC, 50/60 Hz, 0.3 A
Serial check_circle
Additional resources